Product Reference Guide (Supporting software release 4.4.0.0)

Brocade Mobility 5181 Access Point Product Reference Guide 315
53-1002516-01
System Commands
8
system cold start : disable
system config changed : disable
rogue ap detection : disable
ap radar detection : disable
wpa counter measure : disable
Client hotspot status : disable
vlan : disable
lan monitor : disable
DynDNS Update : enable
For information on configuring SNMP traps using the applet (GUI), see “Enabling SNMP traps” on
page 69.
BR5181>admin(system.snmp.traps)> set
Description
Sets SNMP trap parameters.
Syntax
set Client-assoc enable/disable
Enables/disables the Client associated
trap.
Client-unassoc enable/disable
Enables/disables the Client
unassociated trap.
Client-deny-assoc enable/disable
Enables/disables the Client
association denied trap.
Client-deny-auth enable/disable
Enables/disables the Client
authentication denied trap.
snmp-auth enable/disable
Enables/disables the authentication
failure trap.
snmp-acl enable/disable
Enables/disables the SNMP ACL
violation trap.
port enable/disable
Enables/disables the physical port
status trap.
dos-attack enable/disable
Enables/disables the denial of service
trap.
dyndns-update enable/disable
Enables/disables dyndns update trap.
interval <rate>
Sets denial of service trap interval.
cold enable/disable
Enables/disables the system cold start
trap.
cfg enable/disable
Enables/disables a configuration
changes trap.
rogue-ap enable/disable
Enables/disables a trap when a
rogue-ap is detected.
ap-radar enable/disable
Enables/disables the AP Radar
Detection trap.
wpa-counter enable/disable
Enables/disables the WPA counter
measure trap.