Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) Manual

182 Brocade Mobility 7131N-FGR Product Reference Guide
53-1001947-01
Configuring VPN tunnels
6
1. Ensure the WAN ports are connected via the internet
2. Select Network Configuration -> WAN -> VPN from the Brocade Mobility 7131N-FGR Access
Point menu tree.
3. Enter any tunnel name (tunnel names do not need to match).
4. Enter the WAN port IP address of AP #1 in the Local WAN IP field
5. Enter the LAN IP subnet and mask of AP #2 in the Remote Subnet and Remote Subnet Mask
fields,
6. Enter the WAN port IP address of AP #2 in the Remote Gateway field
7. C lic k Add to add the tunnel to the list.
8. Select the Auto (IKE) Key Exchange button.
9. Select Auto Key Settings.
10. Select ESP with Authentication and AES 128-bit. Click OK.
11. Select the IKE Settings button.
12. Select Pre Shared Key (PSK).
13. Enter the Passphrase.
Passphrases must match on both VPN devices.
14. Select AES 128-bit.
15. Select Group 2.
16. Click OK.
This will take you back to the main VPN configuration screen.
17. Click Apply to save the updates
18. Select Network Configuration -> WAN -> VPN -> VPN Status from the Brocade Mobility
7131N-FGR Access Point menu tree. Check the VPN status on the access point.