Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) Manual

436 Brocade Mobility 7131N-FGR Product Reference Guide
53-1001947-01
System commands
8
BR7131N>admin(system.snmp.traps)> show
Shows SNMP trap parameters.
Syntax
Example
admin(system.snmp.traps)>show trap
SNMP MU Traps
mu associated : enable
mu unassociated : disable
mu denied association : disable
mu denied authentication : disable
SNMP Traps
snmp authentication failure : disable
snmp acl violation : disable
SNMP Network Traps
physical port status change : enable
denial of service : enable
denial of service trap rate limit : 10 seconds
SNMP System Traps
system cold start : disable
system config changed : disable
rogue ap detection : disable
ap radar detection : disable
wpa counter measure : disable
mu hotspot status : disable
vlan : disable
lan monitor : disable
DynDNS Update : enable
wlan kerb auth failed : disable
For information on configuring SNMP traps using the applet (GUI), see “Configuring specific SNMP
traps” on page 84.
show trap
Shows SNMP trap parameter settings.
rate-trap
Shows SNMP rate-trap parameter settings.