Administrators Guide (Supporting Fabric OS v7.3.0) Manual

Using only “--show”
In this form, the report lists the following information for each port:
• Port Number
• Port type
‐ D (disable port)
‐ DIA (D_Port)
‐ DP (persistently disabled port)
‐ E (E_Port)
‐ F (F_Port)
‐ G (G_Port)
‐ T (Trunk port)
‐ TF (F_Port trunk)
‐ U (U_Port)
NOTE
The MAPSSAM report does not include the health status of gigabyte Ethernet
(GbE) ports.
• Total up time — Percentage of time the port was up.
• Total down time — Percentage of time the port was faulty.
• Down occurrence — Number of times the port was faulty.
• Total Offline time — Percentage of time the port was offline.
• Number of ports
All percentages are based on the total time the switch was up or down since the
switch was rebooted, MAPS was activated, or the mapsSam --clear command
was last run.
The following example shows typical output for mapsSam --show.
switch0:FID128:admin> mapssam --show
Total Total Down Total
Port Type Up Time Down Time Occurrence Offline Time
(Percent) (Percent) (Times) (Percent)
======================================================================
0 F 100.00 0.00 0 0.00
1 F 100.00 0.00 0 0.00
2 U 0.00 0.00 0 100.00
3 F 100.00 0.00 0 0.00
4 D 0.00 0.00 0 100.00
5 D 0.00 0.00 0 100.00
6 D 0.00 0.00 0 100.00
7 D 0.00 0.00 0 100.00
Number of ports: 8
Using “--show cpu”
The following example shows the output for mapsSam --show cpu.
switch:admin> mapssam --show cpu memory
Showing Cpu Usage:
CPU Usage : 3.0%
Additional MAPS Features
Monitoring and Alerting Policy Suite Administrator's Guide 93
53-1003147-01