Service IronWare Administration Guide (Supporting R05.6.00) User Manual

160 Multi-Service IronWare Administration Guide
53-1003028-02
CFM monitoring and show commands
6
Displaying CFM configurations
The show cfm command, displays the current configuration and status of CFM. For the show cfm
command to take effect, CFM should first be enabled in Protocol Configuration mode.
Syntax: show cfm [domain name ] [ma ma-name]
The domain name parameter specifies a domain for display. By default, all defined domains are
shown.
The ma ma-name parameter specifies the maintenance association name. By default, all defined
domains are shown.
TABLE 28 Show CFM output descriptions
This field... Displays...
Domain The Domain is the network or the part of the network for which faults in connectivity
are displayed.
Index The Domain Index.
Level The level is the domain level in the range 0-7. The levels can be:
• Customer’s MD levels: 5 - 7
• Provider’s MD levels: 3 - 4
• Operator’s MD levels: 0 – 2
Maintenance Association The maintenance association name.
Ma Index The Maintenance Association Index.
CCM interval The time interval between two successive Continuity Check messages (CCMs) that
are sent by MEPs in the specified Maintenance Domain.
VLAN ID The VLAN identifier of the maintenance association.
VPLS ID The VPLS identifier of the maintenance association.
Priority The priority of the CCM messages, sent by MEPs, in the range 0-7.
MEP The maintenance end point ID
Direction DIsplays the direction the MEP was sent:
Up - The MEP direction away from the monitored VLAN.
Down - The MEP direction is towards the monitored VLAN.
MAC DIsplays the associated MAC Address.
PORT DIsplays the associated port.
Brocade#show cfm
Domain: md2
Index: 1
Level: 6
Maintenance association: ma2
Ma Index: 1
CCM interval: 10000 ms
VLAN ID: 2
Priority: 6
MEP Direction MAC PORT
==== ========= ========= ====
3 DOWN 0000.00f7.3831 ethe 2/2