Service IronWare Administration Guide (Supporting R05.6.00) User Manual

162 Multi-Service IronWare Administration Guide
53-1003028-02
CFM monitoring and show commands
6
Displaying connectivity statistics
The show cfm connectivity command, displays connectivity statistics for the remote database. For
the show cfm connectivity command to take effect, CFM should first be enabled in the Protocol
Configuration mode.
Syntax: show cfm connectivity
Sample configuration for a customer’s domain
FIGURE 9 Sample configuration
TABLE 30 Show CFM connectivity output descriptions
This field... Displays...
Domain The Domain is the network or the part of the network for which faults in connectivity
are displayed.
Index The Domain Index.
Level The level is the domain level in the range 0-7. The levels can be:
• Customer’s MD levels: 5 - 7
• Provider’s MD levels: 3 - 4
• Operator’s MD levels: 0 - 2
Maintenance association The maintenance association name.
Ma Index The Maintenance Association Index.
CCM interval The time interval between two successive Continuity Check messages (CCMs) that
are sent by MEPs in the specified Maintenance Domain.
VPLS ID The VPLS identifier of the maintenance association.
Priority The priority of the CCM messages, sent by MEPs, in the range 0-7.
RMEP The remote maintenance end point ID
MAC DIsplays the associated MAC Address.
VLAN or VC VLAN ID or VC label learned from the CCM packet. VC label is in hexadecimal format.
Age Uptime since RMEP discovery or from last age out
PORT DIsplays the associated port.
SLOTMASK Mask of slots that are receiving CCM packets which are used for multi-slot trunks.
For example a value of 0005 indicates Slots 1 and 3.
Brocade#show cfm connectivity
Domain: md2 Index: 1
Level: 6
Maintenance association: ma2
MA Index: 1
CCM interval: 10000 ms
VLAN ID: 2
Priority: 6
RMEP MAC VLAN/PEER AGE PORT SLOTS
==== ===== =============== ======= ======== =========
2 0000.00f7.3931 2 20 2/2 2