Service IronWare Administration Guide (Supporting R05.6.00) User Manual

228 Multi-Service IronWare Administration Guide
53-1003028-02
CFM monitoring for ISID
6
1 0000.00ef.2a0b N/A 799 1/1 1 OK None
2 0000.0011.86d1 N/A 796 1/2 1 OK None
Brocade_DUT_3#show cfm connectivity
Domain: d7 Index: 1
Level: 7
Maintenance association: link
MA Index: 1
CCM interval: 1000 ms
LINK MA ID: N/A
Priority: 7
ETH-AIS TX: DISABLED
ETH-AIS RX: DISABLED
ETH-AIS Interval: 10 sec
RMEP MAC VLAN/PEER AGE PORT SLOTS STATE AIS_STATE
==== ===== ======== ========== ==== ======== ========= ======== =========
4 0000.0011.634b N/A 869 1/2 1 OK None
Loop back messages
CFM loopback
Use the cfm loopback command to display loopback messages.
Syntax: cfm loopback domain domain-name ma ma-name src-mep ID target-mep ID
The following output shows the Loopback messages.
Brocade_DUT_1#cfm loopback domain d7 ma link src-mep 2 target-mep 3
DOT1AG: Sending 10 Loopback to 0000.0011.6351, timeout 10000 msec
Type Control-c to abort
Reply from 0000.0011.6351: time=1ms
Reply from 0000.0011.6351: time<1ms
Reply from 0000.0011.6351: time<1ms
Reply from 0000.0011.6351: time<1ms
Reply from 0000.0011.6351: time<1ms
Reply from 0000.0011.6351: time<1ms
Reply from 0000.0011.6351: time<1ms
Reply from 0000.0011.6351: time<1ms
Reply from 0000.0011.6351: time<1ms
Reply from 0000.0011.6351: time<1ms
sent = 10 number = 10 A total of 10 loopback replies received.
Success rate is 100 percent (10/10), round-trip min/avg/max=0/0/1 ms.
CFM linktrace
Use the cfm linktrace command to display linktrace messages.
Syntax: cfm linktrace domain domain-name ma ma-name src-mep ID target-mep ID
The following output shows the linktrace messages.
Brocade_DUT_1#cfm linktrace domain d7 ma link src-mep 2 target-mep 3
Link trace functionality is not supported on Link-MA.