Service IronWare Administration Guide (Supporting R05.6.00) User Manual

Multi-Service IronWare Administration Guide 229
53-1003028-02
CFM monitoring for ISID
6
Port status TLV
Port status TLV is carried in every CCM message and it carries the state of transmitting port
The state can be either 1 or 2
2 – Port state is Forwarding
1 - Port state other than Forwarding
Port status TLV is supported for sub-second timers from PBIF version 0x56 onwards
Port status TLV is supported for all type of VLANs
CVLAN, SVAN, ISID and BVLAN
Port status TLV is not applicable for Link MA
Configuring Port Status TLV
Port status TLV is optional and will be carried in a CCM message only if it is enabled in the MEP
configuration. Use the following command to enable port-status-tlv at the MEP level.
Syntax: [no] mep id dir tlv-type port-status-tlv port portId
Sample configuration of Port Status TLV
The following configuration shows the process of enabling port status TLV at the MEP level.
Brocade_DUT_1(config)#cfm-enable
Brocade_DUT_1(config-cfm)#domain-name customer level 7
Brocade_DUT_1(config-cfm-md-customer)#ma-name admin vlan-id 100 priority 7
Brocade_DUT_1(config-cfm-md-customer-ma-admin)#ccm-interval 1-second
Brocade_DUT_1(config-cfm-md-customer-ma-admin)#mep 1 down tlv-type
port-status-tlv port eth 1/1
Brocade_DUT_2(config)#cfm-enable
Brocade_DUT_2(config-cfm)#domain-name customer level 7
Brocade_DUT_2(config-cfm-md-customer)#ma-name admin vlan-id 100 priority 7
Brocade_DUT_2(config-cfm-md-customer-ma-admin)#ccm-interval 1-second
Brocade_DUT_3(config)#cfm-enable
Brocade_DUT_3(config-cfm)#domain-name customer level 7
Brocade_DUT_3(config-cfm-md-customer)#ma-name admin vlan-id 100 priority 7
Brocade_DUT_3(config-cfm-md-customer-ma-admin)#ccm-interval 1-second
Brocade_DUT_3(config-cfm-md-customer-ma-admin)#mep 2 down tlv-type
port-status-tlv port ethe 1/2
Show commands
The following commands are used to display the port status tlv at MEP.
Show cfm
Use the show cfm command to display the cfm configuration.
Syntax: show cfm