Service IronWare Administration Guide (Supporting R05.6.00) User Manual

Multi-Service IronWare Administration Guide 303
53-1003028-02
Chapter
9
Foundry Direct Routing and CAM Partition Profiles for the
NetIron XMR and the Brocade MLX Series
Table 46 displays the individual devices and the Foundry Direct Routing (FDR) and CAM Partition
features they support.
Configuring Density Mode for the 2x100G CAM
NOTE
There is no configuration support for cam-mode in NetIron CES and NetIron CER.
Setting the CAM to double density mode will automatically disable uRPF, while uRPF is allowed
under single density mode. The default setting for the XMR is double density. The default setting for
the MLX is single density. You can set the density mode using the following command:
Brocade(config)# cam-mode ip urpf-100g
You must reload the device for this command to take effect.
Syntax: [no] cam-mode ip urpf-100g
Configuring IPv6 host CAM mode
NOTE
There is no configuration support for cam-mode in NetIron CES and NetIron CER.
TABLE 46 Supported Foundry Direct Routing and CAM partition features
Features
supported
Brocade
NetIron XMR
Series
Brocade
MLX Series
Brocade
NetIron CES
2000 Series
BASE
package
Brocade
NetIron CES
2000 Series
ME_PREM
package
Brocade
NetIron CES
2000 Series
L3_PREM
package
Brocade
NetIron CER
2000 Series
Base
package
Brocade
NetIron CER
2000 Series
Advanced
Services
package
Foundry Direct
Routing
Yes Yes Yes Yes Yes Yes Yes
CAM Partition
Profiles
Yes Yes No No No No No
Supernet CAM
Partition
Sharing
Yes Yes No No No No No
CAM Overflow
Logging
Yes Yes No No No No No
IPv6 Host CAM
Enhancement
Yes Yes No No No No No