Service IronWare Administration Guide (Supporting R05.6.00) User Manual

320 Multi-Service IronWare Administration Guide
53-1003028-02
CAM partition profiles
9
Syntax: show cam l4 slot/port
The slot/port parameter specifies the port for which you want to display the CAM entries.
Table 53 describes the output parameters of the show cam l4 slot/port command.
Show cam label-out
To display Outbound Label ACL CAMs, enter the following command.
Syntax: show cam label-out slot/port
Show IFL CAM partition
To display information about the IFL CAM partition, enter the following command.
Syntax: show cam ifl slot/port
TABLE 53 Output parameters of the show cam l4 command
Field Description
LP Shows the number of the interface module.
Index (Hex) Shows the row number of this entry in the IP route table.
Src IP Dest IP Shows the source IP address and the destination IP address.
SPort DPort Shows the source port ID and the destination port ID.
Pro Shows the type of the protocol (TCP, UDP) used.
Age Shows whether the age is enabled or disabled.
IFL/ VLAN Shows the VLAN to which the port belongs.
Out IF Action Shows the state of outgoing interface action.
Group Shows the group address.
PRAM (Hex) Shows the ACL PRAM entries.
Brocade# show cam label-out 2/1
Slot Index Port Outer Lbl Inner Lbl MAC Action
2 0xc0000 2/1 1024 1025 0000.0034.5678 Drop
2 0xc0002 2/1 1027 1028 0000.0034.5577 Drop
Brocade#show cam ifl 2/1
Slot Index Port Outer VLAN Inner VLAN PRAM IFL ID
(Hex) (Hex)
2 00c5fff 2/1 100 200 185fff 4096