Service IronWare Administration Guide (Supporting R05.6.00) User Manual

368 Multi-Service IronWare Administration Guide
53-1003028-02
Syslog messages
A
Notification ISIS Entered Overload State Due to
overload-reason
The device has set the overload bit to on
(1), indicating that the device’s IS-IS
resources are Overloaded.
Reasons for the overload as expressed in
the overload-reason variable are:
• Configuration
• Startup Configuration
• LSP Buffer Allocation Failure
• LSP Header Allocation Failure
• Maximum Number of LSPs Exceeded
• LSP Fragmentation Count Exceeded
• LSP Sequence Number Wrap Around
• LSP Option Allocation Failure
• Path Entry Allocation Failure
• Route Entry Allocation Failure
Definitions of the overload-reason values
are described in Table 75.
Notification ISIS Exited Overload State The device has set the overload bit to off
(0), indicating that the device’s IS-IS
resources are no longer overloaded.
Notification ISIS L1 ADJACENCY DOWN system-id on
circuit circuit-id
The device’s adjacency with this Level-1 IS
has gone down.
The system-id is the system ID of the IS.
The circuit-id is the ID of the circuit over
which the adjacency was established.
Notification ISIS L1 ADJACENCY UP system-id on
circuit circuit-id
The device’s adjacency with this Level-1 IS
has come up.
The system-id is the system ID of the IS.
The circuit-id is the ID of the circuit over
which the adjacency was established.
Notification ISIS L2 ADJACENCY DOWN system-id on
circuit circuit-id
The device’s adjacency with this Level-2 IS
has gone down.
The system-id is the system ID of the IS.
The circuit-id is the ID of the circuit over
which the adjacency was established.
Notification ISIS L2 ADJACENCY UP system-id on
circuit circuit-id
The device’s adjacency with this Level-2 IS
has come up.
The system-id is the system ID of the IS.
The circuit-id is the ID of the circuit over
which the adjacency was established.
TABLE 74 Syslog messages IS-IS (Continued)
Message level Message Explanation