Service IronWare Administration Guide (Supporting R05.6.00) User Manual

Multi-Service IronWare Administration Guide 369
53-1003028-02
Syslog messages
A
Notification ISIS LSP-type LSP LSP-ID Seq
sequence-number Len length LifeTime
lifetime on interface-name dropped due to
LSP-drop-reason
The device has dropped the received LSP.
The LSP-Type can be one of the following:
• L1
• L2
The LSP-ID variable is in the 8 byte LSP ID
value.
The sequence-number is a 4 byte value that
is associated with each LSP ID.
The length is the length of the LSP PDU.
The lifetime is the life period of the LSP.
The interface-name is the name of the
interface and is displayed in the following
form “Ethernet 1/1”.
The LSP-drop-reason variable describes the
following reasons that the LSP was
dropped:
• Adjacency not found
• Adjacency Level Mismatch
• IS Level Mismatch
• Length Too Short
• Length Too Large
• Authentication Failure
• Max Area Check Failure
• Zero Checksum
• Checksum Mismatch
• Invalid Length
Definitions of the LSP-drop-reason values
are described in Table 75.
Notification ISIS NbrType Neighbor
Hostname/systemID DOWN on
interface-name due to
neighbor-down-reason
The device’s Neighbor has gone down.
The NbrType can be one of the following:
• L1
• L2
• PTPT
The interface-name is the name of the
interface and is displayed in the following
form “Ethernet 1/1”.
The neighbor-down-reason variable can be
any one of the following reasons that the
Neighbor is Down:
• BFD Trigger
• Maximum Adjacencies
• User Trigger
• Hold Timer Expiry
• Adjacency ID Mismatch
• Adjacency Type Mismatch
• Interface Down
• Interface State Change
Definitions of the neighbor-down-reason
values are described in Table 75.
TABLE 74 Syslog messages IS-IS (Continued)
Message level Message Explanation