Service IronWare Administration Guide (Supporting R05.6.00) User Manual

54 Multi-Service IronWare Administration Guide

53-1003028-02

Configuring system max values

The mac parameter sets the maximum number of MAC entries.

For minimum, maximum and default values for this parameter refer to Table 9 and Table 10.

The mgmt-port-acl-size parameter sets the maximum size for a management port ACL.

For minimum, maximum and default values for this parameter refer to Table 9 and Table 10.

The subnet-broadcast-acl-cam parameter sets the maximum number of IP broadcast ACL CAM

entries. For minimum, maximum, and default values for this parameter, refer to Table 9.

The receive-cam parameter sets the maximum number of IP Receive ACL software CAM entries.

For minimum, maximum and default values for this parameter refer to Table 9.

The rstp parameter sets the maximum number of RSTP instances.

For minimum, maximum and default values for this parameter refer to Table 9 and Table 10.

The session-limit parameter sets the maximum number of sessions.

For minimum, maximum and default values for this parameter refer to Table 9 and Table 10.

The spanning-tree parameter sets the maximum number of spanning-tree instances.

For minimum, maximum and default values for this parameter refer to Table 9 and Table 10.

The virtual-interface parameter sets the maximum number of virtual interfaces.

For minimum, maximum and default values for this parameter refer to Table 9 and Table 10.

The vlan parameter sets the maximum number of VLANs.

For minimum, maximum and default values for this parameter refer to Table 9 and Table 10.

The vpls-mac parameter sets the maximum number of VPLS MAC Entries.

For minimum, maximum and default values for this parameter refer to Table 9.

The vpls-num parameter sets the maximum number of Virtual Private LAN Services (VPLS). For

minimum, maximum and default values for this parameter refer to Table 9

The ecmp-pram-block-size parameter is used as a limiting factor when programing ECMP nexthops

(v4/v6/vpnv4/vpnv6).Even though the control plane supports up to 32 nexthops per a route, the

actual number of nexthops which are programmed in HW is controlled by this command.If

system-max ecmp-pram-block-size

is configured to a value lesser than the value configured for ip

load-sharing or ipv6 load-sharing, or if ip load-sharing or ipv6 load-sharing is configured to a value

greater than that configured for system-max ecmp-pram-block-size, a warning message will be

displayed. For minimum, maximum and default values for this parameter refer to Table 9

TABLE 11 System max ifl-cam values available by CAM profile on Brocade NetIron XMR and

Brocade MLX series

CAM profile Minimum value Maximum value Default value

Default 0 57344 8192

ipv4 0 114688 8192

ipv6 01310728192

l2-metro 0 114688 8192

mpls-l3vpn 0 114688 8192

mpls-vpls 0 114688 8192

multi-service 0 49152 8192

multi-service-2 0 81920 8192

vpn-vpls 0 114688 8192

ipv4-vpn 0 114688 8192