Service IronWare Administration Guide (Supporting R05.6.00) User Manual

Multi-Service IronWare Administration Guide 61

53-1003028-02

Monitoring dynamic memory allocation

Miscellaneous elements

Monitoring dynamic memory allocation

After a configured system-max value is accepted, it is possible that the dynamic memory allocation

may fail in a running system. To monitor the amount of available memory on the Management

Module and the Interface Module, a timer will check the memory every 10 seconds. If the available

memory falls below 5 percent of the total installed memory, the timer will log the following warning

message.

The warning message is displayed at a frequency of 1 log per 5 minutes.

NOTE

Notifications and traps are sent.

TABLE 15 Miscellaneous elements

Miscellaneous elements Revertible: yes or no

session-limit yes

ip-filter-sys no

mgmt-port-acl-size no

l2-acl-table-entries no

ipv6-cache yes

ipv6-route yes

IPVRF MAX ROUTES yes

mgmt-port-acl-size no

receive-cam no

IPGRE no

LSP_ACL no

SERVICE_LOOKUP no

IP_SRC_GUARD_CAM no

IPv4 MCAST CAM no

IPv6 MCAST CAM no

SERVER_TRUNKS no

CONFIG_FILE_SIZE no

Brocade# show log

…

Jan 17 22:55:55:N: WARN: Current Total Free Memory on MP is below 5 percent of

Installed Memory.

…

Jan 17 23:53:55:N: WARN: Current Total Free Memory on LP 8 is below 5 percent of

Installed Memory.