User Manual v12.3.0 Owner's manual

Brocade Network Advisor IP User Manual 991
53-1003153-01
LSP
29
• Maximum Rate - Sets the maximum data rate supported for data bursts above the
mean rate.
• Maximum Burst - Sets the maximum number of bytes that can be handled at the
maximum rate.
- Use LSP for OSPF shortcuts - Enables the use of traffic engineering data carried in OSPF
extensions that contain information about the interface’s metric, bandwidth reservations,
and admin group memberships.
- Use LSP for IS-IS shortcuts - Enables you to configure the IS-IS shortcut parameters. This
setting allows you to configure the target product to send out IS-IS TE packets for all of its
MPLS-enabled interfaces.
When an MPLS-enabled product receives an IS-IS TE packet, it stores the traffic
engineering information in its Traffic Engineering database (TED). The product then uses
information in the TED when performing calculations to determine a path for an LSP.
 Level — Select a level (level1 or level2) for the LSP.
 Relative Metric — Enter a relative metric (-16777215 through 16777215) for the LSP.
 Announce check box — Select to enable announce for the LSP. The default is 10.
 Announce Metric — Only available when you select the Announce check box. Enter an
announce metric (1 through 16777215) for the LSP.
9. Select the Paths tab (Figure 407).
FIGURE 407 RSVP LSP Advanced Settings Paths tab
From the Paths tab you can configure primary and secondary paths for the LSP.