User Manual v12.3.0 Owner's manual

1006 Brocade Network Advisor IP User Manual

53-1003153-01

VLL manager

3. Click Next.

The VLL Configuration wizard Port Configuration dialog box displays (Figure 420).

FIGURE 420 VLL Configuration wizard Port Configuration dialog box

The last discovered port settings for VLLs are displayed in the Discovered Endpoint Settings

table. You can make changes to the settings in the Configured Endpoint Settings table.

4. To configure port settings for a port that has not been configured, select a port from the

interfaces tree and click Add to add a row to the Configured Endpoint Settings table.

NOTE

You must configure two endpoints.

Provide the following information:

a. From the Tag Mode list, select one of the following:

• Tagged: If the endpoint is a tagged port, the device transmits the packet with the

specified VLAN ID and forwards it out the specified interface.

• Untagged: If the endpoint is an untagged port, the device removes any VLAN ID before

transmitting it out the specified interface.

b. For tagged ports only, enter a VLAN ID for the service provider end point tag in the Outer

VLAN ID field.

Packets with this VLAN ID are transmitted out the specified interface. If you configure dual

tagged (inner and outer VLAN ID) endpoints, make sure you meet the following

requirements:

• Requires an Ethernet router, Core router, or Backbone router with firmware version 5.0

and later.

• You can only define a specific Inner VLAN ID/Outer VLAN ID combination once for all

VLL or VPLS instances.