User Manual v12.3.0 Owner's manual

1242 Brocade Network Advisor IP User Manual
53-1003153-01
Adding a configuration policy manager
37
FIGURE 528 Add Configuration Policy Manager dialog box, Hosts Checks tab
a. Select the Check for redundant connections to attached fabrics check box to determine if
there are at least the minimum number of configured physical connections between the
host and the attached fabric.
The default is 2. For more information about this check and a fix for rule violations, refer to
“Host configuration policy managers” on page 1233.
b. Enter the minimum number of connections between the host and the attached fabric in
the Minimum Connections field.
The default is 2.
c. Select the Check for connections through two fabrics to each target LUN check box to
determine if there are redundant connections between the host group and the target LUN.
For more information about this check and a fix for rule violations, refer to “Host
configuration policy managers” on page 1233.
d. Select the hosts to which you want to apply this policy in the Available Hosts list and click
the right arrow button.
NOTE
You can use the All Host target in the Available Hosts list for future provisioning. Select All
Hosts and click the right arrow button to apply this policy to all discovered hosts.
The selected hosts display in the Selected Hosts list.
9. To set configuration policy managers for the Management application (Figure 529), complete
the following steps.