User Manual v12.3.0 Owner's manual

1396 Brocade Network Advisor IP User Manual
53-1003153-01
Host adapter reports
41
Adapters Faulty SFP report
The Adapters Faulty SFP report lists all Brocade adapters with unsupported or faulty small
form-factor pluggable (SFP) transceivers. This report is only available for Brocade adapters.
For adapters with unsupported SFPs, this report is the same as the Adapters Inventory report
filtered to show only those hosts with adapter ports that have unsupported SFPs. For a complete
list of fields and components of the Adapters Inventory report, refer to the “Adapters Inventory
report” on page 1395.
For adapters with degrading SFPs, there are additional columns in the table that show the
SFP/SFP+ and pluggable optical module (POM) properties for the degrading SFP.
Table 128 describes the SFP and POM fields of the Adapters Faulty SFP Report.
Media The type of media; for example, 8G-sw (8 Gbps software).
FC Address The port’s Fibre Channel address.
Fabric Name The name of the Fabric.
Zone Alias The alternate name of the zone.
Fabric Assigned Address The state (enabled, disabled, or N/A) of the fabric assigned address for the adapter.
WWN Source The source of the world wide name. Options include:
Fabric — The WWN is assigned from the fabric. The fabric assigned address must be
enabled.
Factory — The WWN is assigned at the factory.
N/A — Not applicable.
Boot Over SAN Whether Boot over SAN is enabled or disabled.
Max Supported Speed The maximum speed that is supported on the port. For the FC port, the maximum
speed is 8 Gbps.
Status The status of the Ethernet port; for example, Linkup or Linkdown.
TABLE 128 Adapters Faulty SFP report fields and components
Field/Component Description
SFP Supported Whether the SFP is supported or not.
Connector Type The type of port connector; for example, LC. SC, or Cu (copper cable).
Transceiver The type of transceiver; for example, SFP or SFP+.
Media The type of media for the transceiver; for example, single mode.
Speed The port speed.
Extended ID The identifier for the extended link.
Encoding Displays how the extended link is encoded, for example, 8B10B.
Baud Rate The transmission rate, roughly equivalent to the number of bits per second.
Length 9U1 The length of the single-mode fiber-optic cable, used in situations where gigabit
performance is not required (for distances greater than 100 meters).
Length 9U2 The length of the single-mode fiber-optic cable, used in situations where gigabit
performance is not required (for distances greater than 100 meters).
TABLE 127 Adapters Inventory report fields and components (Continued)
Field/Component Description