User Manual v12.3.0 Owner's manual

Brocade Network Advisor IP User Manual 649
53-1003153-01
Network OS switches in VCS mode
17
Viewing LAGs in VCS mode
1. Launch the DCB Configuration dialog box using one of the following methods:
• Select Configure > DCB from the menu bar.
• Right-click the DCB switch from the device tree, and select Configure > DCB.
• Right-click the DCB switch from the topology map and select Configure > DCB.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select a Network OS switch LAG in the DCB Products/Ports table and click View.
The View LAG dialog box displays, allowing you to view the Network OS switch port parameters.
3. Click one of the following tabs and refer to the appropriate corresponding table for a
description of the feature parameters.
• LAG — “Viewing LAG parameters on the Network OS switch LAG” on page 649
• QoS — Refer to “Viewing QoS parameters on the Network OS switch LAG” on page 650.
• LLDP-DCBX — Refer to “Viewing LLDP-DCBX parameters on the Network OS switch LAG” on
page 652.
• FCoE — Refer to “Viewing FCoE parameters on the Network OS switch” on page 643.
Viewing LAG parameters on the Network OS switch LAG
Table 74 describes the parameters that displays on the View LAG dialog box — LAG tab.
Re-authentication Interval (sec) The number of seconds between re-authentication attempts. The value
range is 1 to 4294967295. The default value is 3600 seconds. This
feature is not dependent on the re-authentication state being enabled.
Port Control The authorization mode to configure the ports for authorization. Options
include Auto, Force-authorized, or Force-unauthorized. The default value
is Auto.
TABLE 74 LAG parameters on the Network OS switch LAG
Field/Component Description
LAG ID For Network OS switches in VCS mode, the LAG ID range is from 1
through 6144. For Network OS switches in standalone mode, the LAG ID
range is from 1 through 64.
Interface Mode The interface mode, which can be none or layer 2 (L2).
Profile Indicates whether the LAG profile is enabled or disabled.
L2 Mode The L2 mode (Access or Trunk):
• Access mode allows only one VLAN and allows only untagged
frames.
• Trunk mode allows more than one VLAN association and allows
tagged frames.
NOTE: <profile> displays if the LAG is profiled.
TABLE 73 802.1x parameter on the Network OS switch port (Continued)
Field/Component Description