User Manual v12.1.0 Instruction Manual

Brocade Network Advisor SAN + IP User Manual 1503
53-1002949-01
SAN connection utilization
43
Changing connection utilization percentages
You can change the utilization percentages.
To change the utilization percentages, complete the following steps.
1. Click the change link in the Utilization Legend, as shown in Figure 649 on page 1503.
FIGURE 649 Utilization Legend in edit mode
2. Enter or select the end percentage you want for the blue line.
When you make a change to the end percentage of a utilization line, you also change the start
percentage for the utilization line immediately above the one you changed when you click
apply. For example, if you change the blue line end percentage to 60 the yellow line start
percentage changes to 60 when you click apply.
3. Enter or select the end percentage you want for the yellow line.
4. Click the apply link.
The new values appear in the Utilization Legend.