User Manual v12.1.0 Instruction Manual

1586 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Provisioning flows
44
7. Select Persist over switch reboots to persist flow definitions over reboots.
Configuring Basic Options
Use the following steps to configure Basic Options on the Add Flow Definition dialog box.
1. Select either Port Address (Port ID) or WWN format for entering the End Device identification.
2. Use one of the following methods to enter End Device Source and Destination identification:
- Type a port ID or WWN in the Source and Destination fields.
- Select the ellipses buttons to the right of Source and Destination fields. Selecting button
displays the Select Device Ports dialog box (Figure 693).
FIGURE 693 Select Device Ports dialog box. (Zones selected)
Use the Show list to display either ports in specific zones or available fabrics, devices, and
ports for selection.
• Selecting Zones from the Show list displays available ports under specific zones as
shown in Figure 693.
• Selecting Products and Ports from the Show list displays available fabrics, devices,
and ports as in Figure 694.