User Manual v12.1.0 Instruction Manual

Brocade Network Advisor SAN + IP User Manual 789
53-1002949-01
Layer 3 access control list policy
22
3. Click Refresh to refresh the hit statistics.
The Refresh Time field displays the last time the Management application client successfully
collected the hit statistics.
Configuring L3 ACL advanced settings
You configure L3 ACL advanced settings for extended L3 ACL device configurations. To configure an
extended L3 ACL, refer to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 777
• “Editing an extended L3 ACL configuration” on page 779
• “Copying an extended L3 ACL configuration” on page 780
• “Creating an IPv6 L3 ACL configuration” on page 781
• “Editing an IPv6 L3 ACL configuration” on page 783
• “Copying an IPv6 L3 ACL configuration” on page 784
To configure advanced settings for an extended L3 ACL configuration, complete the following steps.
1. Click Advanced Settings on the Add/Edit/Duplicate - L3 ACL Configuration dialog box.
FIGURE 280 Advanced Settings dialog box
2. (IPv4 ACL only) Select one of the following types of service (TOS) to use to filter the packet from
the Type of Service list.
• None — Select to not filter by TOS.
• Normal — Select to filter packets that match the normal TOS. The decimal value is 0.
• Other — Select filter by one or more additional options.
3. (IPv4 ACL only) If you selected Other from the Type of Service list, select one or more of
following additional options:
• Min-monetary cost (1) — Select to have the ACL filter packets that match the minimum
monetary cost TOS. The decimal value is 1.
• Max-reliability (2) — Select to have the ACL filter packets that match the maximum
reliability TOS. The decimal is 2.