User Manual v12.1.0 Instruction Manual

Brocade Network Advisor SAN + IP User Manual 793

53-1002949-01

Layer 3 access control list policy

14. Click OK on the Advanced Settings dialog box.

To finish configuring the ACL, return to one of the following procedures:

• “Creating an extended L3 ACL configuration” on page 777

• “Editing an extended L3 ACL configuration” on page 779

• “Copying an extended L3 ACL configuration” on page 780

• “Creating an IPv6 L3 ACL configuration” on page 781

• “Editing an IPv6 L3 ACL configuration” on page 783

• “Copying an IPv6 L3 ACL configuration” on page 784

Network configuration

The Management application allows you to filter traffic from a specific Network. A Network is made

up of one or more devices in a subnet. Use the following procedures to configure a network:

• “Viewing existing networks” on page 793

• “Creating a network” on page 794

• “Editing a network” on page 795

• “Copying a network” on page 796

• “Deleting a network” on page 796

Viewing existing networks

You can access the Network dialog box when configuring a standard or extended L3 ACL device

configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:

• “Creating a standard L3 ACL configuration” on page 773

• “Editing a standard L3 ACL configuration” on page 775

• “Copying a standard L3 ACL configuration” on page 776

• “Creating an extended L3 ACL configuration” on page 777

• “Editing an extended L3 ACL configuration” on page 779

• “Copying an extended L3 ACL configuration” on page 780

To view all existing networks, complete the following steps.