User Manual v12.1.0 Instruction Manual

794 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Layer 3 access control list policy
22
1. Click the Networks tab.
FIGURE 281 Network dialog box, Networks tab
2. Review the List of Networks table:
• Name — The user-defined network name.
• Subnet — The IP address of the subnet.
• Mask — The IP address of the mask.
3. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.
Creating a network
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 773
• “Editing a standard L3 ACL configuration” on page 775
• “Copying a standard L3 ACL configuration” on page 776
• “Creating an extended L3 ACL configuration” on page 777
• “Editing an extended L3 ACL configuration” on page 779
• “Copying an extended L3 ACL configuration” on page 780
To create a network, complete the following steps.
1. Click the Networks tab.
2. Click Add.
The Add Network dialog box displays.
FIGURE 282 Add Network dialog box