User Manual v12.1.0 Instruction Manual

804 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Layer 3 access control list policy
22
FIGURE 286 Add Service dialog box
3. Enter a name for the service in the Name field.
4. Select one of the following protocol options:
• TCP
• UDP
5. Enter a port number in the Port field.
6. Click OK on the Add Service dialog box.
7. Click Close on the Service dialog box.
To finish configuring the advanced settings for the ACL, refer to “Configuring L3 ACL advanced
settings” on page 789.
Editing a service
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 777
• “Editing an extended L3 ACL configuration” on page 779
• “Copying an extended L3 ACL configuration” on page 780
• “Creating an extended L3 ACL configuration” on page 777
• “Editing an IPv6 L3 ACL configuration” on page 783
• “Copying an IPv6 L3 ACL configuration” on page 784
To edit a service, complete the following steps.
1. Click the Services tab.
2. Select the service you want to edit and click Edit.
The Edit Service dialog box displays.
3. Select one of the following protocol options:
• TCP
• UDP
4. Enter a port number in the Port field.
5. Click OK on the Edit Service dialog box.
6. Click Close on the Service dialog box.
To finish configuring the advanced settings for the ACL, refer to “Configuring L3 ACL advanced
settings” on page 789.