User Manual v12.3.0 Owner manual

Brocade Network Advisor SAN + IP User Manual 931
53-1003155-01
Layer 3 access control list policy
22
3. Click Close on the Service dialog box.
To finish configuring the advanced settings for the ACL, refer to “Configuring L3 ACL advanced
settings” on page 912.
Creating a service group
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 899
• “Editing an extended L3 ACL configuration” on page 901
• “Copying an extended L3 ACL configuration” on page 902
• “Creating an extended L3 ACL configuration” on page 899
• “Editing an IPv6 L3 ACL configuration” on page 906
• “Copying an IPv6 L3 ACL configuration” on page 907
To create a service group, complete the following steps.
1. Click the Service Groups tab.
2. Click Add.
The Add Service Group dialog box displays.
FIGURE 361 Add Service Group dialog box
3. Enter a name for the service group in the Name field.
4. To enter a range of ports, complete the following steps.
a. Enter the starting port number in the Start Port field.
b. Enter the ending port number in the End Port field.
c. Click the right arrow button to move the address range to the Selected table.