User Manual v12.3.0 Owner manual

1076 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Creating a new encryption group
25
After configuration of the encryption group is completed, BNAthe Management application
sends API commands to verify the switch configuration.
11. Click Next.
The Next Steps dialog box displays. (Refer to Figure 460.) Instructions for installing public key
certificates for the encryption switch are displayed. These instructions are specific to the key
vault type.
FIGURE 460 Next Steps dialog box
12. Review the post-configuration instructions, which you can copy to a clipboard or print for later.
13. Click Finish to exit the Configure Switch Encryption wizard.
14. Refer to “Understanding configuration status results” on page 1082.
Configuring key vault settings for Key Management
Interoperability Protocol
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to “Creating a new encryption group”
on page 1045.
NOTE:
• With the introduction of Fabric OS 7.1.0, KMIP with SafeNet KeySecure for key management
(SSKM) native hosting LKM is supported. Before selecting KMIP as the key vault type, all nodes
in a KeySecure encryption group must be running Fabric OS 7.1.0 or later.