User Manual v12.3.0 Owner manual

1878 Brocade Network Advisor SAN + IP User Manual

53-1003155-01

Configuration policy manager scheduling

d. Select the hosts to which you want to apply this policy in the Available Hosts list and click

the right arrow button.

NOTE

You can use the All Host target in the Available Hosts list for future provisioning. Select All

Hosts and click the right arrow button to apply this policy to all discovered hosts.

The selected hosts display in the Selected Hosts list.

9. To set configuration policy managers for the Management application (Figure 840), complete

the following steps.

FIGURE 840 Add Configuration Policy Manager dialog box, Management Checks tab

a. Select the Management Checks tab.

b. Select the Check to see if the server backup is enabled and working check box to

determine the following configurations:

• Backup enabled for the Management application server.

• Backup output directory is accessible and writable.

This policy only applies to scheduled backup, not manual (on demand) backup.

For more information about this check and a fix for rule violations, refer to “Management

configuration policy manager” on page 1870.

10. Click OK on the Add Monitor dialog box.

The Configuration Policy Manager dialog box displays with the new configuration policy

manager in the Monitors list.

11. Click Close on the Configuration Policy Manager dialog box.

Configuration policy manager scheduling

You can schedule a configuration policy manager to run automatically. For step-by-step

instructions, refer to the following procedures:

• “Configuring a one-time configuration policy manager schedule” on page 1878

• “Configuring an hourly configuration policy manager schedule” on page 1879

• “Configuring a daily configuration policy manager schedule” on page 1879

• “Configuring a weekly configuration policy manager schedule” on page 1879

• “Configuring a monthly configuration policy manager schedule” on page 1880

Configuring a one-time configuration policy manager schedule

To configure a one-time schedule, complete the following steps.