User Manual v12.3.0 Owner manual

916 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Layer 3 access control list policy
22
14. Click OK on the Advanced Settings dialog box.
To finish configuring the ACL, return to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 899
• “Editing an extended L3 ACL configuration” on page 901
• “Copying an extended L3 ACL configuration” on page 902
• “Creating an IPv6 L3 ACL configuration” on page 903
• “Editing an IPv6 L3 ACL configuration” on page 906
• “Copying an IPv6 L3 ACL configuration” on page 907
Network configuration
The Management application allows you to filter traffic from a specific Network. A Network is made
up of one or more devices in a subnet. Use the following procedures to configure a network:
• “Viewing existing networks” on page 916
• “Creating a network” on page 917
• “Editing a network” on page 918
• “Copying a network” on page 919
• “Deleting a network” on page 919
Viewing existing networks
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 895
• “Editing a standard L3 ACL configuration” on page 897
• “Copying a standard L3 ACL configuration” on page 898
• “Creating an extended L3 ACL configuration” on page 899
• “Editing an extended L3 ACL configuration” on page 901
• “Copying an extended L3 ACL configuration” on page 902
To view all existing networks, complete the following steps.