User Manual v12.3.0 Owner manual

920 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Layer 3 access control list policy
22
3. Click Yes on the confirmation message.
4. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.
Network group configuration
The Management application allows you to filter traffic from a specific network group. A network
group is made up of one or more devices, networks, or network groups. Use the following
procedures to configure a network:
• “Viewing existing network groups” on page 920
• “Creating a network group” on page 921
• “Editing a network group” on page 922
• “Copying a network group” on page 923
• “Deleting a network group” on page 925
Viewing existing network groups
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 895
• “Editing a standard L3 ACL configuration” on page 897
• “Copying a standard L3 ACL configuration” on page 898
• “Creating an extended L3 ACL configuration” on page 899
• “Editing an extended L3 ACL configuration” on page 901
• “Copying an extended L3 ACL configuration” on page 902
To view all existing network groups, complete the following steps.
1. Click the Network Group tab.
FIGURE 356 Network dialog box, Network Group tab