User Manual v12.3.0 User Manual

1130 Brocade Network Advisor SAN User Manual
53-1003154-01
Flow Vision flows
29
Supported port configurations for each feature
Table 90 lists the supported configurations for each Flow Vision feature using only the basic flow
parameters (ingress port and source device, egress port and destination device).
Notes on supported configurations
• If you are using at least one advanced parameter (LUN, frame type, or bidirectional), then
feature-specific rules apply. Refer to the individual Flow Vision features for specific details.
• Neither ranges nor lists are supported for any parameter.
scsi2reserve Only SCSI 2 reserve command frames
scsi3reserve Only SCSI 3 reserve command frames
scsi2release Only SCSI 2 release command frames
scsi3release Only SCSI 3 release command frames
scsiresrel2 Only SCSI 2 reserve-release command frames
scsiresrel3 Only SCSI 3 reserve-release command frames
scsitur Only SCSI test unit ready frames
scsicmdsts Only SCSI command status frames
NOTE: This parameter is valid only for Flow Mirror. It implicitly assumes bidirectional flow
and looks for both SCSI command and status frames.
scsigoodstatus Only SCSI status frames with status marked as good (all 0s (zeros) in status byte)
scsicheckstatus Only SCSI status frames with check status (Check Condition, Busy, Reservation Conflict,
Task Full Set)
scsiinquiry Only SCSI inquiry frames
scsiresvconflict Only SCSI status frames with reservation conflict set
scsixferrdy Only SCSI FCP XFER_RDY (transfer ready) frames
TABLE 90 Port configurations supported in Flow Vision
Feature Platforms Switch Configuration Mode
16 Gbps-capable
Fibre Channel
1
1. 16 Gbps-capable platforms include the FC8-32E and FC8-48E blades.
8 Gbps-capable
Fibre Channel
Access Gateway Virtual Fabric
Flow Monitor Supported
(E_Ports, EX_Ports,
F_Ports, and
XISL_Ports)
Supported
(E_Ports, EX_Ports,
F_Ports, and
XISL_Ports)
Supported
(F_Ports only)
Supported
Flow Generator Supported
(SIM-Ports only)
Supported (Destination
SIM-Ports only)
Not Supported Supported
Flow Mirror Supported (F_Ports and
F_Port trunks)
Not Supported Not Supported Supported
TABLE 89 Supported frame type parameters (Continued)
Frame type parameter Frames counted