User Manual v12.3.0 User Manual

498 Brocade Network Advisor SAN User Manual
53-1003154-01
Enhanced group management
12
Enhanced group management
Use Enhanced Group Management (EGM), a separate licensed feature, to control access to
specific features on Fabric OS devices. The features affected include the following:
• Firmware Download - enables you to perform group firmware download.
For specific instructions for firmware download, refer to “Firmware management” on page 499.
• Security - enables you to perform Group Security Policy Replication.
For specific instructions for security, refer to “Configuration file management” on page 475.
• Configuration Management - enables you to perform Group Configuration Upload and
Replication.
For specific instructions for configuration management, refer to “Tracking changes from the
baseline configuration” on page 490.
Contact The primary contact at the customer site.
Description A description of the customer site.
State The port state, for example, online or offline.
Status The operational status of the port; for example, unknown or marginal.
Right and left arrow buttons Click to move the switches back and forth between the Available
Switches table and the Selected Switches table.
Selected Switches table Lists the switches selected as the destination switches.
Switch Name The name of the switch selected to be the destination switch.
IP The IP address of the switch selected to be the destination switch.
WWN The world wide name of the switch selected to be the destination switch.
Current Firmware Status The status of the current firmware.
TABLE 49 Step 5. Validation
Field/Component Description
Validation Settings table The replication settings that have been configured in previous steps; for
example, the configuration type, source configuration, and destination
settings. Click Finish to approve the settings.
Disable Destination Switch check box Select to disable the destination switch during replication.
TABLE 50 Step 6. Summary
Field/Component Description
Summary table The replication settings that have been successfully applied to the
selected destination switches; for example, the configuration type,
source configuration, and destination settings. Click Close to close the
dialog box.
TABLE 48 Step 4. Select Destination Switches (Continued)
Field/Component Description