Reference v4.1.0 Instruction Manual

972 Network OS Command Reference
53-1003115-01
show qos rcv-queue interface
2
show qos rcv-queue interface
Displays a summary of the runtime ingress queue state information.
Synopsis show qos rcv-queue interface [tengigabitethernet rbridge-id/slot/port |
gigabitethernet rbridge-id/slot/port | all]
Operands tengigabitethernet rbridge-id/slot/port
Specifies a valid 10-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID.
slot Specifies a valid slot number.
port Specifies a valid port number.
gigabitethernet rbridge-id/slot/port
Specifies a valid 1-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID.
slot Specifies a valid slot number.
port Specifies a valid port number.
all Reports QoS configurations for all 10-gigabit Ethernet interfaces within the
system.
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to display a summary of the runtime ingress queue state information applied to
a Layer 2 interface.
Usage Guidelines The gigabitethernet rbridge-id/slot/port parameter is used only on Brocade VDX 6710,
Brocade VDX 8770-4, and Brocade VDX 8770-8 switches.
This command is not supported on Brocade VDX 8770-4 and VDX 8770-8 platforms.
Examples To display the runtime ingress queue state information retrieved from the dataplane for a
10-gigabit Ethernet interface:
switch# show qos rcv-queue interface tengigabitethernet 22/0/2
Interface Ten Gigabit Ethernet 22/0/2
In-use 404019 bytes, Total buffer 1081344 bytes
0 packets dropped
In-use Max
CoS Bytes Bytes
-------------------------
0 0 1081344
1 0 1081344
2 404019 1081344
3 0 1081344
4 0 1081344
5 0 1081344
6 0 1081344
7 0 1081344
See Also show qos rcv-queue multicast