Reference v4.1.0 Instruction Manual

Network OS Command Reference 1073

53-1003115-01

show running-config interface tengigabitethernet sflow

Displays the sFlow configuration for a 10-gigabit Ethernet interface.

Synopsis show running-config interface tengigabitethernet [rbridge-id/slot/port] sflow [enable |

polling-interval | sample-rate]

Operands rbridge-id Specifies a switch by its RBridge ID.

slot Specifies a valid slot number.

port Specifies a valid port number.

enable Displays whether sFlow is enabled for the port.

polling-interval Displays the configured maximum number of seconds between successive

samples of counters to be sent to the collector.

sample-rate Displays the number of packets that are skipped before the next sample is

taken for the interface.

Defaults Displays all sFlow configuration information for the port.

Command Modes Privileged EXEC mode

Description Use this command to display the sFlow configuration for the specified10-gigabit Ethernet

interface.

Usage Guidelines None

Examples

switch# show running-config interface tengigabitethernet 1/0/53 sflow

interface tengigabitethernet 1/0/53

sflow enable

sflow polling-interval 10

sflow sample-rate 100

See Also sflow enable (interface version), sflow polling-interval (interface version),

sflow sample-rate (interface version)