Reference v4.1.0 Instruction Manual

Network OS Command Reference 1079
53-1003115-01
show running-config interface vlan ip
2
show running-config interface vlan ip
Displays the IP configuration of VLAN interfaces.
Synopsis show running-config interface vlan [vlan_id] ip [address | igmp [last-member-query-interval |
query-interval | query-max-response-time | snooping [enable | fast-leave | mrouter |
mrouter-timeout | querier]| static-group static-group-address]| mtu | proxy-arp]
Operands vlan_id Specifies a VLAN. Refer to the Usage Guidelines.
address Displays the IP address configured for VLANs.
igmp Displays whether the Internet Group Management Protocol (IGMP) is
enabled for VLANs.
last-member-query-interval
Displays the amount of time in seconds that the IGMP router waits to
receive a response to a group query message.
query-interval Displays the amount of time in seconds between IGMP query messages
sent by the switch.
query-max-response-time
Displays the configured maximum response time in seconds for IGMP
queries.
snooping Displays IGMP snooping configuration information for VLANs.
enable Indicates whether IGMP snooping is enabled for specified VLANs.
fast-leave Indicates if snooping fast leave is enabled.
mrouter Displays multicast router port information for the VLAN.
mrouter-timeout Displays the configured multicast router IGMP timeout value in seconds.
querier Indicates if IGMP snooping querier is configured.
static-group Displays configured static group membership entries.
static-group-address
Specifies an IPv4 address to return static group information about.
mtu Displays the MTU configured for each VLAN.
proxy-arp Indicates whether a proxy ARP is configured for VLAN interfaces.
Defaults Displays configured information for all VLAN interfaces on the local switch.
Command Modes Privileged EXEC mode
Description Use this command to display the IP configuration for VLAN interfaces.
Usage Guidelines On the Brocade VDX family of switches, VLANs are treated as interfaces from a configuration point
of view. By default, all the DCB ports are assigned to VLAN 1 (VLAN ID equals 1). Valid VLAN IDs
are as follows: