Manualshelf

Reference v4.1.0 Instruction Manual

ManualsBrandsBrocade ManualsComputer AccessoriesNetwork OS Command
1271127212731274127512761277127812791280
1234 Network OS Command Reference
53-1003115-01
source
2
source
Configures the monitoring session.
Synopsis source [fortygigabitethernet rbridge-id/slot/port | tengigabitethernet rbridge-id/slot/port |
gigabitethernet rbridge-id/slot/port] destination [fortygigabitethernet rbridge-id/slot/port |
tengigabitethernet rbridge-id/slot/port | gigabitethernet rbridge-id/slot/port] direction [rx | tx |
both]
no source [fortygigabitethernet rbridge-id/slot/port | tengigabitethernet rbridge-id/slot/port |
gigabitethernet rbridge-id/slot/port] destination [fortygigabitethernet rbridge-id/slot/port |
tengigabitethernet rbridge-id/slot/port | gigabitethernet rbridge-id/slot/port] direction [rx | tx |
both]
Operands fortygigabitethernet
Specifies a valid external 40-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
tengigabitethernet
Specifies a valid external 10-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
gigabitethernet Specifies a valid 1-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
destination Use this parameter to specify the interface.
fortygigabitethernet
Specifies a valid external 40-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
tengigabitethernet
Specif
ies a valid external 10-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
gigabitethernet Specifies a valid 1-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.