Reference v4.1.0 Instruction Manual

Network OS Command Reference 1235
53-1003115-01
source
2
slot Specifies a valid slot number.
port Specifies a valid port number.
direction rx Specifies to monitor the receiving traffic.
direction tx Specifies to monitor the transmitting traffic
direction both Specifies to monitor transmitting and receiving traffic.
Defaults None
Command Modes Monitor session configuration mode
Description Use this command to enable a session for monitoring traffic.
Usage Guidelines The source and destination ports must be in the same port-group on a Brocade VDX 6720-60.
Enter no source followed by the identifying parameters to delete the port mirroring connection for
the specified interface.
Examples To enable session 22 for monitoring traffic:
switch(config)# monitor session 22
switch(config-session-22)# source tengigabitethernet 0/1 destination
tengigabitethernet 0/15 direction both
See Also monitor session