Manualshelf

Reference v4.1.0 Instruction Manual

ManualsBrandsBrocade ManualsComputer AccessoriesNetwork OS Command
1281128212831284128512861287128812891290
1250 Network OS Command Reference
53-1003115-01
spanning-tree vlan
2
spanning-tree vlan
Configures the VLAN identifier for the spanning tree interface.
Synopsis spanning-tree vlan vlan_id
no spanning-tree vlan
Operands vlan vlan_id Sets the VLAN identifier for the spanning tree interface. Refer to the Usage
Guidelines.
Defaults None
Command Modes Interface subtype configuration mode
Description Use this command to set the VLAN identifier for the spanning tree interface.
Usage Guidelines If xSTP is enabled over VCS, this command must be executed on all RBridge nodes.
Enter no spanning-tree vlan to remove the VLAN setting.
On the Brocade VDX family of switches, VLANs are treated as interfaces from a configuration point
of view. By default, all the DCB ports are assigned to VLAN 1 (VLAN ID equals 1). Valid VLAN IDs
are as follows:
• On Brocade VDX 8770 switches: 1 through 4086 for 802.1Q VLANs (VLAN IDs 4087
through 4095 are reserved on these switches), and 4096 through 8191 for service or
transport VFs in a Virtual Fabrics context.
• On all other Brocade VDX switches: 1 through 3962 for 802.1Q VLANs (VLAN IDs 3963
through 4095 are reserved on these switches), and 4096 through 8191 for service or
transport VFs in a Virtual Fabrics context.
Examples None:
See Also forward-delay, max-age, show spanning-tree