Reference v4.1.0 Instruction Manual

1266 Network OS Command Reference
53-1003115-01
support
2
support
Enables or disables the first-fault data capture (FFDC).
Synopsis support ffdc
no support ffdc
Operands ffdc Enables FFDC.
Defaults FFDC is enabled.
Command Modes Global configuration mode
Description Use this command to enable FFDC.
Usage Guidelines This command is supported only on the local switch.
This command is not supported on the standby management module.
Enter no router ffdc to disable FFDC. When disabled, the daemon does not capture any data, even
when a message with FFDC attributes is logged.
Examples To enable FFDC:
switch(config)# support ffdc
To disable FFDC:
switch(config)# no support ffdc
See Also clear support, copy support, show support