Reference v4.1.0 Instruction Manual

1280 Network OS Command Reference

53-1003115-01

switchport port-security sticky

Converts dynamic MAC addresses to sticky secure MAC addresses.

Synopsis switchport port-security sticky mac-address address vlan vlan_id

Operands mac-address address Specifies the MAC address-based VLAN classifier rule used to map to a

specific VLAN.

vlan vlan_id Specifies a VLAN. Refer to the Usage Guidelines.

Defaults None

Command Modes Interface subtype configuration mode

Description You can configure an interface to convert the dynamic MAC addresses to sticky secure MAC

addresses and to add them to the running configuration by enabling sticky learning. When this

command is executed on an interface, the interface converts all the dynamic secure MAC

addresses, including those that were dynamically learned before sticky learning was enabled, to

sticky secure MAC addresses.

Usage Guidelines On the Brocade VDX family of switches, VLANs are treated as interfaces from a configuration point

of view. By default, all the DCB ports are assigned to VLAN 1 (VLAN ID equals 1). Valid VLAN IDs

are as follows:

• On Brocade VDX 8770 switches: 1 through 4086 for 802.1Q VLANs (VLAN IDs 4087

through 4095 are reserved on these switches), and 4096 through 8191 for service or

transport VFs in a Virtual Fabrics context.

• On all other Brocade VDX switches: 1 through 3962 for 802.1Q VLANs (VLAN IDs 3963

through 4095 are reserved on these switches), and 4096 through 8191 for service or

transport VFs in a Virtual Fabrics context.

Examples None