Reference v4.1.0 Instruction Manual

1310 Network OS Command Reference

53-1003115-01

threshold-monitor cpu

Configures monitoring of CPU usage of the system and alerts the user when configured thresholds

are exceeded.

Synopsis threshold-monitor cpu {[actions [none | raslog [{limit limit_when_reached | poll polling_interval |

retry number_of_retries]]}

no threshold-monitor cpu

Operands actions Specifies the action to be taken when a threshold is exceeded.

none No action is taken.

raslog Specifies RASLog messaging.

limit Specifies the baseline CPU usage limit as a percentage of available

resources.

limit_when_reached

When the limit set by this parameter is exceeded, a RASLog WARNING

message is sent. When the usage returns below the limit, a RASLog INFO

message is sent. Valid values range from 0 through 80 percent. The default

is 70 percent.

poll Specifies the polling interval in seconds.

polling_interval The range is from 0 through 3600. The default is 120

retry Specifies the number of polling retries before desired action is taken.

number_of_retries

Range is from 1 through 100. The default is 3.

Defaults Refer to the Operands for specific defaults.

Command Modes RBridge ID configuration mode

Description Use this command to monitor CPU usage and send a RASLog WARNING message when configured

thresholds are exceeded.

Usage Guidelines None

Examples

switch(config-rbridge-id-154)# threshold-monitor cpu actions rasloglimit 50

poll10