Reference v4.1.0 Instruction Manual

Network OS Command Reference 1319
53-1003115-01
threshold-monitor sfp
2
above Enables setting a value for highthresh-action, which specifies the action to
be taken when a high threshold is exceeded.
below Enables setting a value for highthresh-action and lowthresh-action, which
specifies the action to be taken when a low threshold is exceeded.all
Specifies that email and RASLog messaging are used, and that Port
Fencing is applied in the case of highthresh-action only.
all Specifies that email and RASLog messaging are used.
email Specifies that an email message is sent.
none Specifies that no alert is sent.
raslog Specifies RASLog messaging.
limit Specifies the percent of threshold usage, from 0 through 80. The default is
75.
poll Specifies the polling interval in seconds, from 0 through 3600. The default
is 120.
retry Specifies the number of polling retries before desired action is taken, from
1 through 100. The default is 3.
threshold Specifies the values for high, low, buffer, and timebase thresholds. These
values are used to trigger different alerts and Port Fencing.
buffer An integer value.
high-threshold An integer value.
low-threshold An integer value.
timebase Calculates differences between current and previous data taken over a
variety of intervals, for comparison against the preset threshold boundary.
day Calculates the difference between a current data value and that value a
day ago.
hour Calculates the difference between a current data value and that value an
hour ago.
minute Calculates the difference between a current data value and that value a
minute ago.
none Compares a data value to a threshold boundary level.
Defaults For the default parameter values of the SFP types, refer to the chapter “System Monitor” in
Network OS Administrator’s Guide.
Command Modes RBridge ID configuration mode
Description Use this command to monitor SFP parameters and alert the user when configured thresholds are
exceeded.
Usage Guidelines None
Examples A typical command might look like this:
switch(config)# threshold-monitor sfp custom type QSFP area rxp threshold
high-threshold 2000 low-threshold 1000