Reference v4.1.0 Instruction Manual

Network OS Command Reference 1361

53-1003115-01

vlan classifier rule

Creates a VLAN classifier rule.

Synopsis vlan classifier rule rule_id [[mac mac_address]| [proto {hex_addr encap {ethv2 | nosnapllc |

snapllc}| arp encap {ethv2 | nosnapllc | snapllc}| ip encap {ethv2 | nosnapllc | snapllc}|

ipv6 encap {ethv2 | nosnapllc | snapllc}]]

no vlan classifier rule

Operands rule_id Specifies the VLAN identification rule. Valid values range from 1

through 2556.

mac Specifies the Media Access Control (MAC) list.

mac_address Specifies the MAC address-based VLAN classifier rule used to map to a

specific VLAN.

proto Specifies the protocol to use for the VLAN classifier rule.

hex_addr An Ethernet hexadecimal value. Valid values range from 0x0000

through 0xffff

arp Specifies to use the Address Resolution Protocol.

ip Specifies to use the Internet Protocol.

ipv6 Specifies to use the Internet Protocol version 6.

encap Specifies to encapsulate the Ethernet frames sent for the VLAN classifier

rule.

ethv2 Specifies to use the Ethernet version 2 encapsulated frames.

nosnapllc Specifies to use the Ethernet version 2 non-SNA frames.

snapllc Specifies to use the Ethernet version 2 with SNA frames.

Defaults None

Command Modes Global configuration mode

Description Use this command to dynamically classify Ethernet packets on an untagged interface into VLANs.

Usage Guidelines VLAN classifiers are created individually and are managed separately. Up to 256 VLAN classifiers

can be provisioned. One or more VLAN classifiers can be grouped into a classifier group.

This classifier group can further be applied on an interface.

Enter no vlan classifier rule rule_id to delete the specified rule.

Examples To create an ARP VLAN classifier rule:

switch(config)# vlan classifier rule 2 proto arp encap ethv2