Reference v4.1.0 Instruction Manual

1368 Network OS Command Reference

53-1003115-01

vrrp-group

Configures a virtual router group.

Synopsis vrrp-group group-ID

no vrrp-group group-ID

Operands group-ID A value from 1 through 128 that you assign to the virtual router group.

Defaults None

Command Modes Interface subtype configuration mode

Description Use this command to identify a virtual router group and enters into the virtual router configuration

mode.

Usage Guidelines Enter no vrrp-group group-ID to remove a specific VRRP group. If you remove a group, you cannot

retrieve it. You would have to redo the configuration procedure.

Examples The following example shows how to assign the 10-gigabit Ethernet interface 101/1/6 to the

virtual router group with the ID of 1. (First you must enable VRRP on the switch.)

switch(config)# rbridge-id 101

switch(config-rbridge-id-101)# protocol vrrp

switch(config-rbridge-id-101)# interface tengigabitethernet 101/1/6

switch(config-if-te-101/1/6)# vrrp-group 1

See Also interface, interface ve, virtual-ip