Reference v4.1.0 Instruction Manual

1378 Network OS Command Reference

53-1003115-01

zoning enabled-configuration cfg-name

Enables a zone configuration.

Synopsis zoning enabled-configuration cfg-name cfgName

no zoning enabled-configuration cfg-name

Operands cfgName Specifies the configuration to be enabled.

Defaults Zoning is not implemented and default zoning applies.

Command Modes Global configuration mode

Description Use this command to enable a specific configuration. This command commits the current defined

zone configuration to both volatile and nonvolatile memory.

Usage Guidelines Only one configuration can be enabled at a time.

This command is supported only in Brocade VCS Fabric mode. Zoning configuration data are

automatically distributed among all RBridges in the VCS Fabric. Standalone mode is not

supported.

This command can be entered on any RBridge in a Brocade VCS Fabric, but it is always executed

on the principal RBridge in fabric cluster mode. In logical chassis cluster mode, edits can be

performed only from the principal RBridge.

If the operation fails, the previous state is preserved; that is, zoning remains disabled, or the

previous effective configuration remains in effect. If the operation succeeds, the new configuration

replaces the previous effective configuration.

Enter no zoning enabled-configuration cfg-name to disable the currently enabled configuration.

The VCS Fabric returns to default zoning mode. In this mode, either all devices can access one

another, or no device can access any other device, depending on if the default zoning mode is

ALLACCESS or NOACCESS.

NOTE

If more than 300 devices are connected when the enabled-configuration is disabled, the no zoning

enabled-configuration cfg-name command is not allowed if the defzone mode is AllAccess. In this

case, change the defzone mode to No Access and then disable the enabled-configuration.

Examples To enable a zone configuration:

switch(config)# zoning enabled-configuration cfg-name myconfig

To disable the currently enabled configuration:

switch(config)# no zoning enabled-configuration cfg-name

See Also show running-config zoning defined-configuration,

show running-config zoning enabled-configuration, zoning enabled-configuration cfg-action

cfg-transaction-abort