Reference v4.1.0 Instruction Manual

Network OS Command Reference 1379

53-1003115-01

zoning enabled-configuration default-zone-access

Sets the default zone access mode.

Synopsis zoning enabled-configuration default-zone-access {allaccess | noaccess}

Operands allaccess Sets the default zone access mode to “All Access”. Each device can access

all other devices attached to the VCS Fabric.

noaccess Sets the default zone access mode to “No Access”. No device can access

any other device in the VCS Fabric.

Defaults Zone access mode is “All Access”.

Command Modes Global configuration mode

Description Use this command to display or set the default zone access mode.

Usage Guidelines This command is supported only in Brocade VCS Fabric mode. Zoning configuration data are

automatically distributed among all RBridges in the VCS Fabric. Standalone mode is not

supported.

This command can be entered on any RBridge in a Brocade VCS Fabric, but it is always executed

on the principal RBridge in fabric cluster mode. In logical chassis cluster mode, edits can be

performed only from the principal RBridge.

ATTENTION

Setting the default zone mode initializes a zoning transaction (if one is not already in progress), and

creates reserved zoning objects. For the change to become effective, you must commit the

transaction with either the zoning enabled-configuration cfg-action cfg-save command or the

zoning enabled-configuration cfg-name command.

NOTE

A default zone controls the device access that is in effect when zoning is not enabled. When a

user-specified zoning configuration is not enabled, the default zone is in effect, allowing access to

all devices or no devices. When a user-specified zone configuration is enabled, it overrides the

default zone access mode.

Examples To set the default zone mode to All Access:

switch(config)# zoning enabled-configuration default-zone-access allaccess

See Also zoning enabled-configuration cfg-name, zoning enabled-configuration cfg-action cfg-save