Reference v4.1.0 Instruction Manual

Network OS Command Reference 175
53-1003115-01
debug dhcp packet buffer interface
2
debug dhcp packet buffer interface
Enables and disables DHCP packet capture on a specific interface.
Synopsis debug dhcp packet buffer interface [vlan vlan_id] [gigabitethernet rbridge-id/slot/port
|tengigabitethernet rbridge-id/slot/port|fortygigabitethernet rbridge-id/slot/port] [rx | tx]
no debug dhcp packet buffer interface [vlan vlan_id] [gigabitethernet rbridge-id/slot/port [rx | tx]
|tengigabitethernet rbridge-id/slot/port| [rx | tx] fortygigabitethernet rbridge-id/slot/port] [rx | tx]
debug dhcp packet buffer all
no debug dhcp packet buffer all
Operands all Enables DHCP packet capture on all switch interfaces.
vlan vlan_id VLAN identification of the interface where you want to enable or disable
DHCP packet buffer capture.
gigabitethernet rbridge-id/slot/port A valid 1-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
rx | tx Specifies whether to capture transmitted or received packets. If not
specified, both are captured.
tengigabitethernet rbridge-id/slot/port A valid 10-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
rx | tx Specifies whether to capture transmitted or received packets. If not
specified, both are captured.
fortygigabitethernet rbridge-id/slot/port A valid 40-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
rx | tx Specifies whether to capture transmitted or received packets. If not
specified, both are captured.
Defaults None
Command Modes Privileged EXEC mode
Description Enables or
disables capture of DHCP packets on all or specified interfaces.
Usage Guidelines The all operand replaces the interface operand.
Use the no form of this command to disable DHCP packet capture on a specific switch interface
when used with debug dhcp packet buffer interface [interface specifications]