Reference v4.1.0 Instruction Manual

Network OS Command Reference 183
53-1003115-01
debug ip igmp
2
debug ip igmp
Enables debugging for IGMP information.
Synopsis debug ip igmp {all | group A.B.C.D | interface {tengigabitethernet rbridge-id/slot/port |
gigabitethernet rbridge-id/slot/port | port-channel number | vlan vlan_id}}
no debug ip igmp
Operands all Displays all values.
group A.B.C.D Specifies the group address, as a subnet number in dotted decimal format
(for example, 10.0.0.1), as the allowable range of addresses included in
the multicast group.
interface Use this parameter to specify the interface to be monitored.
tengigabitethernet rbridge-id/slot/port
Specifies a valid 10-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
gigabitethernet rbridge-id/slot/port
Specifies a valid 1-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
port-channel number
Specifies the interface is a port-channel. The number of available channels
range from 1 through 63 for standalone mode, and from 1 through 6144
for Brocade VCS Fabric mode. However, the channel can be assigned any
number from 1 through 6144.
vlan vlan_id Specifies which VLAN interface to display the snooping configuration
related information. Refer to the Usage Guidelines.
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to enable or disable debugging for IGMP. This will display all of the IGMP
packets received and sent, and IGMP-host related events.
Usage Guidelines Use the no form of this command to disable debugging.
On the Brocade VDX family of switches, VLANs are treated as interfaces from a configuration point
of view. By default, all the DCB ports are assigned to VLAN 1 (VLAN ID equals 1). Valid VLAN IDs
are as follows: