Reference v4.1.0 Instruction Manual

190 Network OS Command Reference
53-1003115-01
debug lacp
2
debug lacp
Enables debugging for the Link Aggregation Control Protocol (LACP).
Synopsis debug lacp {all | cli | event | ha | pdu [rx {all | interface tengigabitethernet rbridge-id/slot/port |
interface gigabitethernet rbridge-id/slot/port}| tx {all |
interface fortygigabitethernet rbridge-id/slot/port |
interface tengigabitethernet rbridge-id/slot/port |
interface gigabitethernet rbridge-id/slot/port}] | sync | timer | trace level number}
no debug lacp
Operands all Turns on all debugging.
cli Turns on command line interface debugging.
event Turns on event debugging.
ha Echo HA events to the console.
pdu Echo PDU content to the console.
rx all Turns on debugging for received LACP packets on all interfaces.
rx interface Turns on debugging for received LACP packets on the specified interface.
interface tengigabitethernet rbridge-id/slot/port
Specifies the 10-gigabit Ethernet interface.
rbridge-id Specifies the routing bridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
interface gigabitethernet rbridge-id/slot/port
Specifies a valid 1-gigabit Ethernet interface.
rbridge-id Specifies the routing bridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
tx all Turns on debugging for transmitted LACP packets on all interfaces.
tx interface Turns on debugging for transmitted LACP packets on the specified
interface.
interface fortygigabitethernet rbridge-id/slot/port
Specifies the 40-gigabit Ethernet interface.
rbridge-id Specifies the routing bridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specif
ies a valid port number.
interface tengigabitethernet rbridge-id/slot/port
Specifies the 10-gigabit Ethernet interface.
rbridge-id Specifies the routing bridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.