Reference v4.1.0 Instruction Manual

Network OS Command Reference 201
53-1003115-01
debug vrrp
2
port Specifies a valid port number.
ve vlan_id Specifies the VLAN number for a virtual Ethernet (VE) interface.
packets recv Debugs packets received.
packets sent Debugs packets sent.
session VRID Specifies the virtual group ID to debug. Valid values range from 1
through 128.
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to enable or disable debugging for VRRP traffic. You can, for example, capture
event and packet information for all virtual groups or for a specific interface.
Usage Guidelines This command is for VRRP and VRRP-E. VRRP-E supports only the VE interface type.
Enter no debug vrrp all with to disable all VRRP debugging.
Enter no debug vrrp followed by specific events or packet parameters to remove a specific VRRP
debugging configuration.
Examples To set debugging on sent and received packets for a 10-gigabit Ethernet interface that has an
rbridge-id/slot/port of 121/0/50:
switch# debug vrrp packets interface tengigabitethernet 121/0/50
To set debugging for a session for a VRRP virtual group called vrrp-group-25:
switch# debug vrrp session 25
See Also vrrp-extended-group, vrrp-group